UV Tester
UV reliability testing.
Due to the uncontrollability and variation of climate conditions in the real world, UV reliability testing in the lab can not only accelerate the speed of tests and replicate the aging conditions based on requirements, but also guarantee the accuracy and repeatability of the tests.
All Real Technology UV Tester features high-level UVA+UVB output that can complete the testing within one week;
The features the following advantages:
?UV irradiation can be easily controlled
?Minimum level of maintenance required
?Uniform UV irradiation to the test samples
?Long lifespan of lamp tubes with stable output
 
 
 
? This equipment is UL certified, TUV tested in accordance with IEC 61215 and IEC61646 standards.
? Dual samples can be tested simultaneously.
? Configurable testing procedure （UVA, UVB can be tested individually or simultaneously）
? Heat pads are applied to the heating module at the rear of the solar module to achieve IEC61646 requirement.
? PID fan control mode for temperature control and temperature monitoring points are available to monitor the internal and module temperatures.
? Specially-designed UV sensor can automatically extend and measure the UV light source. The interval for extension can be configured between 10min and 1hr to avoid wear-and-tear of the sensor resulting in data deviation.
? UV lamp can be easily replaced within 30 mins.
 
 
 
Product Total Output Life Dimensions
UV-A Lamp 250W （320nm-400nm） 500 hrs （W）2000 *（D）2000mm*（H）2700mm
UV-B Lamp 25W （280nm-320nm） 3,000 hrs
 
 
 
? Inner sensor between door and light source to protect the operator from exposure to UV light while testing is running.
? Temperature safety-switch to automatically disconnect the power and submit the alarm when the system’s internal temperature exceeds 80℃
? System electrical circuit is grounded.
? Short-circuit breaker to prevent electric shock hazards.
 
System UV light source - UV